It’s pretty easy to find the candelabra style glass hurricane candle holder at thrift stores, garage sales and Grandma’s attic. Today, I’m focusing on the ones that have a peg base that sits in a candlestick. You should be able to find these at a super reasonable price. 

The same principle can be used for empty candle jars or old candle jars with a little remaining wax in them.  Almost any glass vessels will work as long as they have a solid base with no drainage holes. 

Why Fill the Hurricane Instead of Just Using a Votive?

I am so often disappointed by votives and tea lights, the wicks don’t stay lit, or they don’t give off enough light or they don’t last long enough.

This way, the candles burn for hours and hours!

I can control the scent and color if I want any.

It’s a great way to use up all the scraps of leftover wax, discolored and damaged candles that I have mysteriously accumulated and turn them into an entirely new candle.

With clear glass, I much prefer the look of the hurricanes filled over votives that fit some well, and other too small much prefer the look over.

It highlights the variety of mismatched shapes, yet unifies them.

mismatched filled hurricane candle are lit on a marble topped chest

Note: some links may be affiliate links which means if you purchase something using these links, I may receive a small commission. But you pay nothing more for this service, I appreciate you usinig my links whenever possible to help compensate me for making content you enjoy.

TABLE OF CONTENTS:

Let’s Repurpose Candles & Hurricane Candle Holders

Materials and Supplies:

  • Wax — newly purchase wax or old candle wax from from unused candles, from spent candles scraps and bits of remaining wax in candle jars
  • Candle Wick — old wick or fresh wick
  • Glass Peg Hurricane candle holders or decorative containers (see NOTE below)
  • Essential Oils or candle scents, optional
  • Egg carton, small cups, etc.
  • Sharp knife
  • Dedicated cutting board
  • Disposable spoons
  • Skewers, clothespins, wire — whatever works for you
  • Hot glue gun and glue, optional
  • Double boiler arrangement
  • Oven mitt

NOTE: I collected mine over a bit of time. If you like the mismatched look, but need them quickly, they are some clear ones available here, and more clear ones here and more vintage votives here.

If you prefer a matched look, these sets are available.

Step 1) Start by Cleaning all Your Glass Jars–

ten mismatched hurricane candle holders are draining on a counter mat

The temptation here is to use a butter knife. I get it. But honestly, it is too easy to damage the glass.

NOTE: A damaged glass jar or hurricane can break when heated with a burning candle.

Use a sturdy disposable spoon or knife if you must. Start with gently working the tip of the spoon under any remaining wax and forcing it loose. 

If that doesn’t work for the larger clumps, try freezing it. The wax will contract a bit and then you will have a better shot at getting the spoon to pop it loose.

You may be tempted to microwave the jar, but be cautious with this. Often, wicks are held in place by a little metal disc. This will not make your microwave happy!!! 

For ones that I could visually verify did not have a metal disc, I zapped them briefly upside down on a paper towel. No enough to melt it, just to loosen the chunks so they would come out freely.

When you have just a bit of wax residue remaining. Washing it in HOT soapy water will be enough to take care of that. I like to wipe it down well with a paper towel first, so the paper towel absorbs all the melted wax. And then I give it polish with a kitchen dish towel.

Step 2) Prepare Your Hurricane Candle Holders–

cleaned hurricane candle holders are draining on a counter mat next to two dried in an egg carton and another in a dish towe

For any glass candle holder that has a peg bottom like mine, you need to come up with a way to hold them upright and straight. 

I used an egg container, which worked great for four of them. For several more, I used coffee cups (more narrow cups than say mugs). And for yet a few more, I had some little blue nesting condiment dishes in my pantry, and the smallest ones held two more of my candle holders.

Look around and I’m sure you’ll find something that works. You can always fall back on cutting one-inch lengths of paper towel tubes.

Step 3) Prepare Your Wax–

Four large pillar candles resting on a cutting board with a chef's knife nearby

I bought four large white unscented candles at my favorite thrift store for $6 total.

closeup of knife scraping dirt spots off a pillar candle

First, with a small paring knife scrape off any marks, stains, dirt, etc. 

woman's hands cutting the end off a pillar candle

Then with a large chef’s knife I set to work cutting them into small chunks to melt.

The best way to melt wax is to use a double boiler set up — basically a smaller pan or pot over a larger pan of hot water.

I picked up the top part of a true double boiler at the thrift store. You can use a regular small pot resting inside a larger pot. You just need to make sure you can hold the small pan securely to pour the hot wax.

overhead view of wax melting in a double boiler on a cooktop

Fill the larger pot with water an inch or two deep — enough that the smaller pan with touch the water but no so much that the water will overflow.

I start by using medium heat and then lower it a bit. Candle wax typically has a rather low melting point. Keep an eye on it and stir fairly often. 

As soon as it is just about all melted I remove it from the heat. Little slivers will continue to melt even as it is cooling down a bit.

PRO TIP: Do not pour wax at its hottest, that will encourage tunneling and cratering as it cools in the jar

A quick pause in the action so that I may ask if you are enjoying this post. Would you like more, How about free printables? How about exclusive offers? Please subscribe for All the things:

Thanks bunches! Now back to the candles:

Step 4) Wick Your Candle Hurricanes or Jars–

hurricane candle holder resting on a mug with wick held in place with clothespin and wire

The final preparation of your hurricane candle holders or jars is to wick them. I tried a variety of ways. 

I dropped one of the candles on our brick floor and it broke cleanly in half. As I picked it up, I was able to slide one half right off the wick. So I decided to save the wicks too. 

I started by cutting off the base end of the candle to get to the bottom of the wick easier. Some I was able to pull out once the bottom was exposed, and some I had to chip out.

Honestly, wicking is so cheap, I probably won’t do that again, unless there is enough to save a trip to the store.

You can buy new wicks that are already prepared with metal discs to secure the bottom. However, I did not have luck with them. The wicks were fine and I used them, but they all pulled out of their discs. 

The system that worked best for me to attach the wick was

  1. Folded about 1/2-inch of one end of each wick at a right angle
  2. With a disposable spoon, I added 2 spoonfuls of hot wax in the bottom of the cup. Or you can use a couple of drops of hot glue.
  3. Held that little foot of the wick in the hot wax until it cooled.
  4. Laid a skewer across the top 
  5. Attached the wick to the skewer with a thin piece of wire

Step 5) Pour Your New Candles–

mismatched hurricane candle holder fill the countertop

As mentioned before, tunneling and cratering are fairly common candle-making oops. 

To reduce these, I let my wax cool until it is still pourable, but not very hot. You can tell that it is cooling as it becomes more and more opaque.

PRO TIP: to speed this up a bit, you can gently stir the melted wax to release its heat and set it on a wire rack to help the bottom of the pot cool faster.

Carefully, pour the warm wax in your container stopping about a 1/4-inch below where you want the top.

As it cools, watch for the wax pulling away from the wick and forming a crater. If it does, while the wax is still “spongy”, use a skewer and poke two or three holes in the crater. Then pour more wax into the crater to fill the tunnels and any voids and top off your candle.

If you are a perfectionist and have a heat gun, after filling any craters or tunnels, you can heat the top of the candle to melt it into a smooth, flat pool. But this is totally not necessary.

Now let your candles sit undisturbed for 24 hours. 

I know, it doesn’t seem like they need that much time. But leaving them to cure will help them burn longer and more steady.

Step 6) Lastly, Trim the Wick

closeup of scissors snipping off the extra wick in a finished candle

Now it’s time to trim the wick. Always cut your wick to about 1/4-inch length. You should also do this when relighting candles. Candles should always have a wick length of about 1/4-inches before you light them.

TIP: If your wick is too low in a container to reach easily with scissors, try nail clippers instead.

What I Would Do Differently!

mismatched hurricane candle holder fill the countertop

I wish I hadn’t filled them quite so high.

I got ahead of myself thinking about how long these would burn, that I forgot one of the prettiest parts of these hurricanes are the different patterns of shadows the candlelight creates. And the hurricanes that have carving look so pretty with the flame shining through the designs.

However, I filled the hurricanes higher than I should have to maximize the effect of the pretty hurricanes. Restraint is not necessarily a strength of mine . . . . sigh!

So, I can use a heat gun to heat the top and remove some, or I can light the candles and burn them down a bit. One is more labor intensive and one is prettier. Hmmm, can you guess which I’ll do?

Creative Ideas For Using Your New Candles

mismatched filled hurricane candle are lit on a marble topped chest

There are many fun ways to use your new candles. 

I made these in anticipation of a long centerpiece I want. I made this long box for a mantel display. And I have a new shorter version in white you can see I used on this buffet table and this Christmas mantel. I plan to use these ten mismatched hurricane candles with the white box down the length of the table.

When the weather gets warmer and we’re all outside so much, these will be a great addition in black iron candelabras and candle holders on the patio, the balcony and even on the front knee wall to great our guests.

With the peg bases, I like to stick them in florist foam or chicken wire and arrange flowers around them.

Aren’t they beautiful? I can’t believe how long many of those have been hanging out in my stash. Can’t wait to have them out shining their beautiful light.

Pin this (or any of the images on this post for when you find a treasure of hurricane candle holders of your own.

three mismatched votive hurricane candles under a title: Hurricane Candles DIY: stylish, Easy, Cheap

Please share how you’d use them. Do you ever see these hurricane candle cups when you’re out treasure hunting?

round image of Diane smiling next to a Signature that reads: With Joy, Diane

2 Comments

  1. Missy

    What a great idea, Diane! This would be such a great idea for a wedding! Ooh la la! Love the tip about the nail clippers…gold tip!

    Reply
    • Diane

      Thanks Missy! It sure would! Your so right — as usual!

      Reply

Submit a Comment

Your email address will not be published. Required fields are marked *

Diane Sudhoff
key with a tags that reads "Subscribers" Next to the words "Free Printables Library"
Heading that Reads: Most Popular Organizing Posts

Click Image to

Jump to  Post

closeup of layers of velvet lined jewelry trays in a dresser drawer
shelves holding shoes attached to the legs of a repurposed piano bench
view of storage tubs on rollers on a wall-mounted rack close to the ceiling
bundles of faux flowers are stored on the side off a large painted HVAC system
painted clay hearts hanging from lichhen covered branches
Shamrock shaped meringue cookies on a plate and parchment covered baking sheet
closeup of throw pillows decorated with thick plush yarn in lovers' knots
Copyright © 2024 South House Designs